Veritas Dynamic Multi-Pathing 6.0.1 Release Notes - HP-UX


Veritas™ Dynamic Multi-Pathing 6.0.1 Release Notes - HP-UX


1. Dynamic Multi-Pathing Release Notes
About this document
About Veritas Dynamic Multi-Pathing (DMP)
About Symantec Operations Readiness Tools
Important release information
Changes introduced in DMP 6.0.1
New versioning process for SFHA Solutions products
New directory location for the documentation on the software media
Dynamic Reconfiguration tool
Changes related to installation and upgrades
System requirements
Hardware compatibility list
Supported HP-UX 11i v3 operating systems
DMP: issues fixed in 6.0.1
Installation and upgrades: issues fixed in 6.0.1
Dynamic Multi-Pathing: issues fixed in 6.0.1
Known issues
DMP path discovery behavior when a device is removed from PowerPath control (2144891)
Path name character limit when converting LVM volumes over DMP to VxVM volumes over DMP (2035399)
Changes in enclosure attributes are not persistent after an upgrade to VxVM 6.0.1 (2082414)
Enclosure name limitation when using HP-UX LVM pvcreate command on DMP device
Adding a DMP device or its OS device path as a foreign disk is not supported (2062230)
The pvcreate command failed with DMP devices on IA machines (2482178)
Continuous trespass loop when a CLARiiON LUN is mapped to a different host than its snapshot (2761567)
In some cases with large LUN setup, the storage disappears after DMP device scan (2828328)
Installation known issues
Software limitations
DMP settings for NetApp storage attached environment
LVM volume group in unusable state if last path is excluded from DMP (1976620)
DMP does not support devices in the same enclosure that are configured in different modes (2643506)
Documentation set
Manual pages

Terms of use for this information are found in Legal Notices.



Did this article answer your question or resolve your issue?


Did this article save you the trouble of contacting technical support?


How can we make this article more helpful?

Email Address (Optional)