Please enter search query.
Search <product_name> all support & community content...
Article: 100052024
Last Published: 2021-12-07
Ratings: 0 0
Product(s): APTARE IT Analytics
Problem
When scoping Aptare reports by Policy additional hosts/policies are shown.
Engineering has stated that this is working as designed.
Error Message
No Error Message
Cause
When Aptare creates the report, it uses the list of host names in the policy and not the policy name. The results will show output for all hosts within the policy regardless of the policy you selected.
Example using screenshot below: If the ADV_nbclient1 policy is selected, Aptare uses the host name nbclient1. The results will then show all data for that host resulting in data from both ADV_nbclient1 and AIR_nbclient1 policies.
Solution
Instead you can run the report you want and Filter by Policy